Commands Listed in Alphabetical Order
Syntax
POWer:SWLoss:
CONDuction:POWer:MEAN?
Examples
POWER:SWLOSS:CONDUCTION:POWER:MEAN? might return
:POWER:SWLOSS:CONDUCTION:POWER:MEAN 1 indicating that the
mean conduction power switching loss calculation is set to 1 W.
POWer:SWLoss:CONDuction:POWer:MIN? (Query Only)
Returns the minimum conduction power for the switching loss calculation.
Conditions
This command requires a DPO4PWR application module for 4000 series models,
or an MDO3PWR application module for MDO3000 series models.
Group
Power
Syntax
POWer:SWLoss:CONDuction:POWer:MIN?
Examples
POWER:SWLOSS:CONDUCTION:POWER:MIN? might return
:POWER:SWLOSS:CONDUCTION:POWER:MIN
1
indicating that the
minimum conduction power switching loss calculation is set to 1 W.
POWer:SWLoss:DISplay
This command specifies the display selection for switching loss results: All
measurements, energy loss measurements or power loss measurements.
Conditions
This command requires a DPO4PWR application module for 4000 series models,
or an MDO3PWR application module for MDO3000 series models.
Group
Power
Syntax
POWer:SWLoss:DISplay {ALL|ENERGYLoss|POWERLoss}
POWer:SWLoss:DISplay?
Arguments
ALL displays both energy and power loss measurements in the results.
ENERGYLoss displays only energy loss measurements in the results.
POWERLoss displays only power loss measurements in the results.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-521
To Next Page
Loading...
Need help?
General
