Commands Listed in Alphabetical Order
SEARCH:SEARCH
<x>:TRIGger:A:BUS:B<x>:ARINC429A:LABel:Q UALifier?
might return EQUAL indicating the label qualifier is set to =.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ARINC429A:LABel:VALue
This command specifies the low value to be used when searching on the
ARINC429 bus label field. The search condition must be set to LABel or
LABELANDDATA (using SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:
ARINC429A:CONDition). The defa
ultisallX's(don'tcare).SEARCH<x>isthe
search number, which is always 1. B<x> is the bus number.
Conditions
This command requires install
ation of a DPO4AERO application module for
MDO4000C models, or MDO3AERO for MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:AR INC429A:LABel:VALue
<QString>
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:AR INC429A:LABel:VALue?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ARINC429A:CONDition
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ARINC429A:LABel:HIVALue
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ARINC429A:LABel:QUALifier
Arguments
QString is a quoted string of 8 bits. The allowable characters are 0, 1, and X.
The bits specified in the quoted string replace the least significant bits, leaving
any unspecified upper bits unchanged.
Examples
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:AR INC429A:LABel:VALue
"XXXX1000" sets the upper limit of the range to XXXX1000.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:AR INC429A:LABel:VALue?
might return "XXXXXXXX".
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ARINC429A:SDI
This command specifies the value for the SDI field to be used when searching
on the ARINC429 bus data field(s). The search condition must be set to DATA
or LABELANDDATA (using SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:
ARINC429A:CONDition). The default is all X's (don't care). SEARCH<x> is the
search number, which is always 1. B<x> is the bus number.
2-618 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
