Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
Related Commands
SEARCH:SEARCH
<x>:TRIGger:A:BUS:B<x>:ETHERnet:CONDition
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ETHERnet:DATa:VALue
Arguments
NR1 is an integer. The minimum and default values are -1 (don't care) and the
maximum is 1,499.
Examples
SEARCH:SEARCH1:TRIGger:A:BUS:B1:ETHERn et:DATa:OFFSet 36 sets
the data offset to 36 bytes.
SEARCH:SEARCH1:TRIGger:A:BUS:B1:ETHERn et:DATa:OFFSet? might
return –1, indicating that the data offset value is the default value, –1, meaning
“don’t care”.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ETHERnet:DATa:SIZe
When the search condition is set to DATa,
this command specifies the number of
contiguous TCP/IPv4/MAC client data bytes to search for.
SEARCH<x> is the
search number, which is always 1, and
B<x> is the bus number 1-4. 1-3 for the
MDO4000C and 1-2 for the MDO3000.
Conditions
This command requires a DPO4ENET application module for DPO/MSO4000B
and MDO4000/B/C models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ET HERnet:DATa:SIZe <NR1>
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ET HERnet:DATa:SIZe?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ETHERnet:CONDition
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ETHERnet:QUALifier
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ETHERnet:DATa:VALue
Arguments
NR1 is an integer. The minimum and default values are 1 and maximum is 16,
except when the qualifier is set to either
INrange or OUTrange. In these cases,
the maximum size is 4.
Examples
SEARCH:SEARCH1:TRIGger:A:BUS:B1:ETHERn et:DATa:SIZe “4” se
ts the
oscilloscope to search for 4 contiguous data bytes.
2-634 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English