Commands Listed in Alphabetical Order
Conditions
This command re
quires a DPO4AUTOMAX application module for
DPO/MSO4000B and MDO4000/B/C models or MDO3FLEX application module
for MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FL EXray:EOFTYPE
{STATic|DYNAMic|ANY}
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FL EXray:EOFTYPE?
Arguments
STATic sets the FlexRay end of frame type to STATIC.
DYNAMic sets the FlexRay end of frame type to DYNAMIC.
ANY sets the FlexRay end of frame type to ANY type.
Examples
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRA Y:EOFTYPE ANY sets the
FlexRay end of frame type to any type.
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRA Y:EOFTYPE? might return
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRA Y:EOFTYPE STATIC
indicating the FlexRay end of frame type is static.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FLEXray:ERRTYPE
This command specifies the error type to use when searching on the
FlexRay bus signal. The search condition needs to be set to ERROR (using
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FLEXray:CONDition).
SEARCH<x> is the search number, which is always 1, and B<x>
Conditions
This command requires a DPO4AUTOMAX application module for
DPO/MSO4000B and MDO4000/B/C models or MDO3FLEX application module
for MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FL EXray:ERRTYPE
{CRCHeader|CRCTrailer|SYNCFrame|STARTu pnosync|NULLFRStatic|
NULLFRDynamic}
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FL EXray:ERRTYPE?
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-655
To Next Page
Loading...
Need help?
General
