Commands Listed in Alphabetical Order
Syntax
SEARCH:SEARCH
<x>:TRIGger:A:BUS:B<x>:USB:SPLit:SE:VALue
{NOCARE|FULLSPeed|LOWSPeed|ISOSTART|IS OMID|ISOEND|ISOALL}
SEARCH:SEARC
H<x>:TRIGger:A:BUS:B<x>:USB:SPLit:SE:VA Lue?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:USB:SPECIALType
Arguments
NOCARE — any combination of S and E bits.
FULLSPeed — S bit = 0, E bit = 0.
LOWSPeed — S bit = 1, E bit = 0.
ISOSTART — S bit = 1, E bit = 0.
ISOMID — see note above.
ISOEND — see note above.
ISOALL — see note above.
Examples
SEARCH:SEARCH1:TRIGger:A:BUS:B1:USB:SP Lit:SE:VALue ISOEND
specifies to search for the ISOEND split transaction value.
SEARCH:SEARCH1:TRIGger:A:BUS:B1:USB:SP Lit:SE:VALue? might
return FULLSPEED.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:USB:TOKENType
This command specifies the token type to be used in a USB search: any, start
of frame, out, in, or setup.
SEARCH<x> is the search number, which is always
1, and
B<x>
Conditions
This command requires the DPO4USB application module to be installed, except
for MDO3000 models, which require the MDO3USB. Note that 1 GHz bandwidth
models are recommended for high-speed (HS) USB.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:US B:TOKENType
{ANY|SOF|OUT|IN|SETUP}
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:US B:TOKENType?
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-715
To Next Page
Loading...
Need help?
General
