Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:THRes hold:RF_AMPlitude
{<NR3>}
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:THRes hold:RF_AMPlitude?
Related Commands
TRIGger:A:LOGIc:THReshold:RF
Examples
SEARCH:SEARCH1:TRIGger:A:LOGIc:THResho ld:RF_AMPlitude 1.5 sets
the search’s threshold to 1.5
V.
SEARCH:SEARCH1:TRIGger:A:LOGIc:THResho ld:RF_AMPlitude? might
return 1.5, indicating that the search’s threshold is 1.5V.
Following is an example command sequence showing how to generate a single
search mark on the RF_AMPLitude waveform when the waveform is logic 0
(less than 1.5V):
SEARCH:SEARCH1:TRIGger:A:LOGIc:THResho ld:RF_AMPlitude 1.5
SEARCH:SEARCH1:TRIGger:A:LO
GIc:INPut:RF_AMPlitude LOW
SEARCH:SEARCH1:STATE 1
SEARCH:SEARCH1:LIST? :SEARC H:SEARCH1:LIST
RF_AMPLITUDE,2.4702,2.4702,2.4702,-19. 0119E-6,0.0E+0,0.0E+0,
0.0E+0
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:THReshold:RF_FREQuency
This command specifies the threshold to use when searching the RF
Frequency vs. Time waveform. (It does the same thing as the command
SEARCH:SEARCH<x>:TRIGger:A:LOWerthresh old:RF_FREQuency.) This
command is used together with SEARCH:SEARCH<x>:TRIGger:A:LOGIc:
INPut:RF_FREQuency to search for an instance when the RF Frequency vs.
Time waveform goes higher or lower than the specified threshold.
SEARCH<x> is
the search number, which is always 1.
Conditions
MDO4000/B/C models only.
Group
Search
Syntax
SEARCH:SE
ARCH<x>:TRIGger:A:LOGIc:THReshold:RF_FR EQuency
{<NR3>}
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:THRes hold:RF_FREQuency?
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-729

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English