Commands Listed in Alphabetical Order
Syntax
SEARCH:SEARCH
<x>:TRIGger:A:SETHold:THReshold:REF<x> <NR3>
SEARCH:SEARCH<x>:TRIGger:A:SETHold:THR eshold:REF<x>?
Arguments
<NR3> is a floating point number that specifies the lower threshold in volts.
SEARCH:SEARCH<x>:TRIGger:A:TIMEOut:POLarity
When searching using the TIMEOut search type, this commands specifies the
polarity to be used. Use the command SEARCH:SEARCH<x>:TRIGger:A:TYPe
to specify the timeout search type.
SEARCH<x> is the search number, which is
always 1.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:TIMEOut:POL arity
{STAYSHigh|STAYSLow|EITher}
SEARCH:SEARCH<x>:TRIGger:A:TIMEOut:POL arity?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:TYPe
SEARCH:SEARCH<x>:TRIGger:A:TIMEOut:SOUrce
SEARCH:SEARCH<x>:TRIGger:A:TIMEOut:TIMe
Arguments
STAYSHigh — Search when the polarity stays high during the timeout time.
STAYSLow — Search when the polarity stays low during the timeout time.
EITher — Search when the polarity is either high or low.
Examples
SEARCH:SEARCH1:TRIGger:A:TIMEOut:POLar ity STAYSHigh specifies to
search for the condition that the polarity stays high during the timeout time.
SEARCH:SEARCH1:TRIGger:A:TIMEOut:POLar ity? might return EITHER.
This indicates that the search has been set for timeout when the polarity remains
either high or low for longer than the specified timeout time.
SEARCH:SEARCH<x>:TRIGger:A:TIMEOut:SOUrce
When searching using the TIMEOut search type, this command specifies the
source. The available sources are live channels, reference waveforms, themath
waveform, or the digital channels. The default is channel 1. The timeout search
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-745
To Next Page
Loading...
Need help?
General
