Commands Listed in Alphabetical Order
type is selecte
dusingSEARCH:SEARCH<x>:TRIGger:A:TYPe.
SEARCH<x> is
the search number, which is always 1.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:TIMEOut:SOU rce
{CH1|CH2|CH3|CH4|MATH|REF1|REF2|REF3|R EF4|D0|D1|D2|D3|
D4|D5|D6|D7|D8|D9|D10|D11|D12|D13|D1
4|D15|
RF_AMPlitude|RF_FREQuency|RF_PHASe}
SEARCH:SEARCH<x>:TRIGger:A:TIMEOut:
SOUrce?
Related Commands
TRIGger:A:TIMEOut:SOUrce
SEARCH:SEARCH<x>:TRIGger:A:TYPe
SEARCH:SEARCH<x>:TRIGger:A:TIMEOut:TIMe
SEARCH:SEARCH<x>:TRIGger:A:TIMEOut:POLarity
Arguments
CH1–4 specifies to use one of the analog channels as the source waveform.
MATH specifies to use the math waveform astheasthesourcewaveform.
REF1–4 specifies to use one of the reference waveforms 1–4 as the as the source
waveform.
D0-D15 specifies to use one of the digital channels as the source waveform.
(MSO/MDO4000/B models only as well as MDO3000 and MDO400C models
with option MDO3MSO or MDO4MSO installed.)
RF_AMPlitude|RF_FREQuency|RF_PHASe specifyanRFtimedomaintraceas
the source. (MDO4000/B/C models only.)
Examples
SEARCH:SEARCH1:TRIGger:A:TIMEOut:SOUrc e CH4 specifies to use
channel 4 as the source for the timeout search.
SEARCH:SEARCH1:TRIGger:A:TIMEOut:SOUrc e? might return CH1,
indicating that channel 1 has been set as the source for the timeout search.
SEARCH:SEARCH<x>:TRIGger:A:TIMEOut:TIMe
When searching using the TIMEOut search type, this command specifies the
timeout time, in seconds. The default and minimum is 4.0E-9 seconds and the
maximum is 8.0 seconds. The resolution is 800.0E-12 which means that the
increments of time specified is 800 picoseconds. The timeout search type is
2-746 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
