Commands Listed in Alphabetical Order
selected using
SEARCH:SEARCH<x>:TRIGger:A:TYPe.
SEARCH<x> is the
search number, which is always 1.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:TIMEOut:TIM e <NR3>
SEARCH:SEARCH<x>:TRIGger:A:TIMEOut:TIM e?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:TYPe
SEARCH:SEARCH<x>:TRIGger:A:TIMEOut:POLarity
SEARCH:SEARCH<x>:TRIGger:A:TIMEOut:SOUrce
Arguments
<NR3> is a floating point number that specifies the timeout time, in seconds. The
default is 8.0000E-9.
Examples
SEARCH:SEARCH1:TRIGger:A:TIMEOut:TIMe 4.0E-9 specifies the timeout
time of 4.0 nsec.
SEARCH:SEARCH1:TRIGger:A:TIMEOut:TIMe? might return 8.0000E-9,
which is the default.
SEARCH:SEARCH<x>:TRIGger:A{:TRANsition|:RISEFall}:DELTatime
This command specifies the transition delta time setting to be used as the value
to compare against when a transition time is found. <
SEARCH<x> is the search
number, which is always 1.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A{:TRANsition |:RISEFall}:DELTatime
<NR3>
SEARCH:SEARCH<x>:TRIGger:A{:TRANsition |:RISEFall}:DELTatime?
Arguments
<NR3> is a floating point number that specifies the transition time, in seconds.
SEARCH:SEARCH<x>:TRIGger:A{:TRANsition|:RISEFall}:POLarity
This command specifies the polarity setting for an transition search to determine
wheretoplaceamark.
SEARCH<x> is the search number, which is always 1.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-747
To Next Page
Loading...
