Commands Listed in Alphabetical Order
Syntax
TRIGger:A:BUS
:B<x>:MIL1553B:DATa:PARity
{0|1|X|ZERo|ONE|NOCARE|OFF|ON}
TRIGger:A:BU
S:B<x>:MIL1553B:DATa:PARity?
Related Commands
TRIGger:A:BUS:B<x>:MIL1553B:CONDition
TRIGger:A:BUS:B<x>:MIL1553B:DATa:VALue
Arguments
0
1
X
sets the value to X (“don’t care”) which is the default.
ZERO sets the value to 0.
ONE sets the value to 1.
NOCARE sets the value to X (“don’t care”) which is the default.
OFF sets the value to 0.
ON sets the value to 1.
Examples
TRIGger:A:BUS:B1:MIL1553B:DATa:PARity 1 sets the data parity bit to be
used in a MIL-STD-1553 bus trigger to 1.
TRIGger:A:BUS:B1:MIL1553B:DATa:PARity? might return 0, indicating that
the data parity bit to be used in a MIL-STD-1553 bus trigger is set to 0.
TRIGger:A:BUS:B<x>:MIL1553B:DATa:VALue
When the MIL-STD-1553 bus trigger condition is set to DATa, this command
specifies the data binary pattern to be used in the trigger. This is a 16-bit field.
The default is all X’s (don’t care).
B<x>
Conditions
This command requires a DPO4AERO application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3AERO application module for
MDO3000 models.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:MIL1553B:DATa:VALue <QString>
TRIGger:A:BUS:B<x>:MIL1553B:DATa:VALue ?
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-839
To Next Page
Loading...
Need help?
General
