Command Descriptions
2–166
TDS Family Oscilloscope Programmer Manual
Miscellaneous
HEADer, SET?, VERBose
*LRN?
*LRN ?
NOTE. The *LRN? query always returns a string including command headers,
regardless of the setting of the HEADer command. This is because the returned
string is intended to be sent back to the digitizing oscilloscope as a command
string. The VERBose command can still be used normally to specify whether the
returned headers should be abbreviated.
*LRN?
a partial response might look like this:
:ACQUIRE:STATE 1;MODE SAMPLE;NUMENV 10;NUMAVG 16;
REPET 1;STOPAFTER RUNSTOP;:DIAG:LOOP:OPTION ONCE;
COUNT 1;:DIAG:STATE HALT;:HEADER 1;:VERBOSE 1;
:CURSOR:FUNCTION OFF;VBARS:UNITS SECONDS;
POSITION1 1.00E-6;POSITION2 9.00E-6;SELECT CURSOR1;
MATH<x>? (Query Only)
Returns the definition for the math waveform specified by <x>.
Vertical
MATH<x>?
MATH
<x> ?
MATH<x>:DEFINE
Allows the user to define new waveforms using mathematical expressions. This
is equivalent to selecting Change Math waveform definition in the Math<x>
side menu.
Group
Related Commands
Syntax
Examples
Group
Syntax
To Next Page
Loading...
Need help?
General
