To Next Page

To Previous Page

Command Groups

TDS Family Oscilloscope Programmer Manual

2–23

itself to the state it was in when you originally saved that setting. Table 2–17

lists these commands.

Table 2–17: Save and Recall Commands

Header Description

 Return number of allocated and unallocated

data points

 Return number of allocated data points

 Return number of unallocated data points

! Specify the number of allocated data points

 Delete stored setup

 Delete stored waveform

 Recall settings

 Recall saved instrument settings



(File System only)

Recall saved waveform

 Save settings

 Save instrument settings

 Save waveform



(TDS 4XXA & 7XXA only)

Specifies the file format for saved waveforms

Status and Error Commands

Table 2–18 lists the status and error commands the digitizing oscilloscope

supports. These commands let you determine the status of the digitizing

oscilloscope and control events.

Several commands and queries used with the digitizing oscilloscope are common

to all devices on the GPIB bus. IEEE Std 488.2–1987 defines these commands

and queries. They begin with an asterisk ().

Table 2–18: Status and Error Commands

Header Description

  Return all events

 Return scope status

 Clear status

Tektronix TDS 700A Programming Manual

Other manuals for Tektronix TDS 700A