Status and Events
3–14
TDS Family Oscilloscope Programmer Manual
Table 3–5 lists the execution errors that are detected during execution of a
command. In these error messages, you should read “macro” as “alias.”
Table 3–5: Execution Error Messages – EXE Bit 4
Code Message
200 Execution error
201 Invalid while in local
202 Settings lost due to rtl
210 Trigger error
211 Trigger ignored
212 Arm ignored
220 Parameter error
221 Settings conflict
222 Data out of range
223 Too much data
224 Illegal parameter value
230 Data corrupt or stale
240 Hardware error
241 Hardware missing
242 Hardware configuration error
243 Hardware I/O device error
250 Mass storage error
251 Missing mass storage
252 Missing media
253 Corrupt media
254 Media full
255 Directory full
256 File name not found
257 File name error
258 Media protected
260 Expression error
261 Math error in expression
2200 Measurement error, Measurement system error
2201 Measurement error, Zero period
2202 Measurement error, No period found
To Next Page
Loading...
Need help?
General
