Command Groups
2-24
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
Because they are computed only when they are requested, immediate
measurements slow the waveform update rate l ess than displayed
measurements.
Use the VALue? query to obtain measurement results of either
displayed or immediate measurements.
Several measurement commands set and query measurem ent
parameters. You can assign some pa rameters, such as waveform
sources, differentl y for each me asurement readout.
Table 2--16 lists and describes Measurement commands.
Table 2- 16: Measurement commands
Header Description
MEASUrement? Return all measurement parameters
MEASUrement:IMMed? Return immediate measurement param-
eters
MEASUrement:IMMed:SOUrce1 Set or query the channel for immediate
measurement
MEASUrement:IMMed:SOUrce2 Set or query the channel for two-source
immediate measurements (TPS2000
with Power Analysis Module only)
MEASUrement:IMMed:TYPe Set or query the immediate measure-
ment to be taken
MEASUrement:IMMed:UNIts? Return the immediate measurement
units
MEASUrement:IMMed:VALue? Return the immediate measurement
result
MEASUrement:MEAS<x>? Return parameters on the periodic
measurement
MEASUrement:MEAS<x>:SOUrce Set or query the channel to take the
periodic measurement from
MEASUrement:MEAS<x>:TYPe Set or query the type of periodic mea-
surement to be taken
To Next Page
Loading...
Need help?
General
