Command Groups
2-16
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
Calibration and Diagnostic Commands
Calibration and Diagnostic commands let you initiate the oscillo-
scope self-ca libration routines and examine the results of diagnostic
tests. Table 2--9 lists and describes Calibration and Diagnostic
commands.
Table 2- 9: Calibration and Diagnostic commands
Header Description
*CAL? Perform an internal self-calibration and
return result status
CALibrate:ABOrt Stop an in-progress factory calibration
CALibrate:CONTINUE Perform the next step in the factory
calibration sequence
CALibrate:FACtory Initialize the factory calibration sequence
CALibrate:INTERNAL Perform an internal self-calibration
CALibrate:STATUS? Return PASS or FAIL status of the last
self- or factory-calibration operation
DIAg:RESUlt:FLAG? Return diagnostic tests status
DIAg:RESUlt:LOG? Return diagnostic test sequence results
ERRLOG:FIRST? Returns first entry from error log
ERRLOG:NEXT? Returns next entry from error log
To Next Page
Loading...
