TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
2-15
Command Groups
This section lists the commands organized by functional group. The
Command Descriptions section, starting on page 2--45, lists all
commands alphabetically.
The oscilloscope GPIB, USB, and RS-232 interfaces conform to
Tektronix standard codes and formats except where noted. The GPIB
interface also conforms to IEEE Std 488.2–1987 except where noted.
The USB interface also conforms to USB Test and Measurement
Class, Subclass USB488 Specification, except where noted.
Acquisition Commands
Acquisition commands affect the acquisition of waveforms. These
commands control mode, averaging, and single-waveform
acquisition. Table 2--8 lists and describes Acquisition commands.
Table 2- 8: Acquisition commands
Header Description
ACQuire? Return acquisition parameters
ACQuire:MODe Set or query the acquisition mode
ACQuire:NUMACq? Return the # of acquisitions obtained
ACQuire:NUMAVg Set or query the number of acquisitions
for average
ACQuire:STATE Start or stop the acquisition system
ACQuire:STOPAfter Set or query the acquisition control
To Next Page
Loading...
Need help?
General
