Command Groups
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
2-25
Table 2- 16: Measurement commands (Cont.)
Header Description
MEASUrement:MEAS<x>:UNIts? Return the units for periodic measure-
ment
MEASUrement:MEAS<x>:VALue? Return periodic measurement results
Miscellaneous Commands
Miscellaneous commands are a group of commands that do not fit
into any other category.
Several commands and queries are common to all 488.2–1987
devices on the GPIB or USB bus, and the device on the RS-232
interface. These commands and queries are defined by IEEE Std.
488.2–1987 and Tekt ronix Standard Codes and Formats 1989 and
begin with an asterisk (*) character. Table 2--17 lists and describes
Miscellaneous commands.
Table 2- 17: Miscellaneous commands
Header Description
AUTORange?
(TDS1000B, TDS2000B, and
TPS2000 only)
Return all autorange parameters
AUTORange:SETTings
(TDS1000B, TDS2000B, and
TPS2000 only)
Set or query the which parameters
autorange can adjust
AUTORange:STATE
(TDS1000B, TDS2000B, and
TPS2000 only)
Set or query the autorange to on or off
AUTOSet Automatic oscilloscope setup
AUTOSet: ENABLE
(TDS1000B and TDS2000B only)
Allows educators to disable or enable the
Autorange and Autoset functions.*
To Next Page
Loading...
Need help?
General
