Tektronix TDS210 - Power and Battery-Related Commands (TPS2000 Only); Power Measurement (TPS2000 with TPS2 PWR1 Power Analysis Application Key Installed Only); Table 2- - 19: Power and Battery-Related Commands

Command Groups
2-28
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
Power and Battery-Related Commands (TPS2000 Only)
Power and Battery-Related commands provide battery management
functions to a TPS2000 oscilloscope.
Table 2--19 lists and describes the Power and Battery-Related
commands.
Table 2- 19: Power and Battery-Related commands (TPS2000 only)
Header Description
POWer? Return all power parameters
POWer:AC:PRESENt? Return whether the oscilloscope is being
powered by battery or AC
POWer:BATTERY<x>:GASgauge? Return the charge remaining in battery x
POWer:BATTERY<x>:STATUS? Return status for battery x
POWer:BATTERIES:TIME? Return the time remaining in both
batteries
POWer:BUTTONLIGHT Turn the lighted front-panel buttons on
and off
Power Measurement (TPS2000 with TPS2PWR1 Power
Analysis Application Key Installed Only)
Power Measurement commands provide power measurements to a
TPS2000 oscilloscope with the TPS2PWR1 Power Analysis
application software key installed.
Table 2--20 lists and describes Power Measurement commands.