Command Descriptions
2-72
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
MAV. (A complete discussion of these registers and bits, and of event handling
in general, begins on page 3--1.)
*CLS can suppress a Service Request that is to be generated by an *OPC. This
will happen if a hardcopy output or single sequence acquisition operation is still
being processed when the *CLS command is executed.
CURSor? (Query Only)
Returns all current cursor settings for the active cursor.
Cursor
CURSor?
CURSOR?
might return :CURSOR:FUNCTION OFF;MODE TRACK;VBARS:UNITS
”s”;POSITION1 1.20000000E-4;POSITION2 1.600000000E-3;VDELTA
4.56E0;HDELTA 1.48E-3;SELECT CURSOR1;HPOS1 4.84E0;HPOS2
2.8E-1;:CURSOR:HBARS:POSITION1 5.52E0;POSITION2 2.48E0;DELTA
3.04E0;SELECT CURSOR1;UNITS ”V” as the current cursor settings.
CURSor:FUNCtion
Selects or returns the cursor type. Cursors are attached to the selected waveform.
WAVEform and GRATicule cursors are only valid in XY or XYZ displays. This
command is equivalent to setting Function in the CURSOR menu.
Cursor
CURSor:FUNCtion { HBArs | OFF | WAVEform | VBArs | GRATicule }
CURSor:FUNCtion?
HBArs specifies horizontal bar cursors that measure vertical parameters (typically
volts).
OFF removes the cursors from the display
VBArs specifies vertical bar cursors that measure horizontal parameters (typically
time).
Group
Syntax
Examples
Group
Syntax
Arguments
To Next Page
Loading...
Need help?
General
