Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2-73
WAVEform specifies waveform XY cursors.
GRATicule specifies graticule XYcursors. TDS3AAM only.
CURSOR:FUNCTION VBARS
selects vertical bar type cursors.
CURSor:GRATicule? (Query Only)
(Available with TDS3AAM)
Returns the current settings for the XY graticule cursors, where XPOSITION1
and YPOSITION1 refers to the reference cursor, and XPOSITION2 and
YPOSITION2 refers to the delta cursor.
Cursor
CURSor:WAVEform?
CURSor:GRATicule?
CURSOR:GRATICULE?
might return :CURSOR:GRATICULE:SELECT CURSOR1Y;XPOSITION1 -5.8E-3;
YPOSITION1 -2.0E0;XPOSITION2 2.2E-3;YPOSITION2 3.2E0.
CURSor:GRAticule:SELect
(Available with TDS3AAM)
Sets (makes active) or returns the specified XY display graticule cursor. This
command is equivalent to pressing the SELECT button on the front panel when
the Graticule cursors are active.
Cursor
CURSor:GRAticule:SELect { CURSOR<n>X | CURSOR<n>Y }
CURSor:GRAticule:SELect?
Examples
Group
Related Commands
Syntax
Examples
Group
Syntax
To Next Page
Loading...
