Tektronix TDS3000 Series - Page 112

Command Descriptions
2-74
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
CURSOR<n>X specifies the X-axis cursor of the specified graticule cursor, where
n = 1 for the reference cursor, and n = 2 for the delta cursor.
CURSOR<n>Y specifies the Y-axis cursor of the specified graticule cursor , where
n = 1 for the reference cursor, and n = 2 for the delta cursor.
CURSOR:GRATICULE:SELECT CURSOR2X
selects the graticule delta X-axis cursor as the active cursor.
CURSor:GRAticule:XPOSITION<x>
(Available with TDS3AAM)
Sets or returns the position of the XY graticule cursor’s X-axis cursor for the
reference or delta cursor.
Cursor
CURSor:GRAticule:XPOSITION<x> <NR3>
CURSor:GRAticule:XPOSITION<x>?
<x> specifies which graticule cursor , where x = 1 for the reference cursor and
x = 2 for the delta cursor.
<NR3> is the X cursor position value.
CURSOR:GRATICULE:XPOSITION1?
might return CURSor:GRAticule:XPOSITION1 -1.44E0
CURSor:GRAticule:YPOSITION<x>
(Available with TDS3AAM)
Sets or returns the position of the XY graticule cursor’s Y-axis cursor for the
reference or delta cursor.
Cursor
CURSor:GRAticule:YPOSITION<x>
CURSor:GRAticule:YPOSITION<x>?
Arguments
Examples
Group
Syntax
Arguments
Examples
Group
Syntax