Command Descriptions
2-78
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
<FIVEdivs> sets H Bar measurement scale so that 5 screen major divisions is
100%, where 0% is --2.5 divisions and 100% is +2.5 divisions from the center
horizontal graticule.
CURSOR:HBARS:USE FIVEdivs
sets the H Bar measurement scale so that 5 screen major divisions equals 100%.
CURSor:HBArs:UNIts
CURSor:MODe
Sets or returns the cursor tracking mode,
Cursor
CURSor:MODe {INDependent | TRACk }
CURSor:MODe?
<INDependent> Sets the cursors to move independently.
<TRACk> sets the cursors to move together when cursor 1 is selected. Enabling
tracking mode automatically selects cursor 1 as the active cursor. If cursor 2 is
selected while in tracking mode, only cursor 2 will move.
CURSOR:MODE TRACK
sets the oscilloscope so that both cursors move at the same time.
CURSor:VBArs:HDELTa? (Query Only)
Returns the horizontal difference between the two vertical bar cursors.
Cursor
CURSor:VBArs:HDELTa?
<NR3> indicates the horizontal difference between the 2 vertical bar cursors. The
units are specified by the CURSor:HBArs:UNIts? query.
Examples
Related Commands
Group
Syntax
Arguments
Examples
Group
Syntax
Returns
To Next Page
Loading...
