Tektronix TDS3000 Series - Page 117

Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2-79
CURSOR:VBARS:HDELTA?
might return :CURSOR:VBARS:HDELTA 1.088000000E-3, indicating the time
between the vertical bar cursors is 1.088 milliseconds.
CURSor:VBArs:UNIts
CURSor:VBArs:HPOS<x>? (Query Only)
Returns the horizontal value of the specified vertical bar ticks.
Cursor
CURSor:VBArs:HPOS<x>?
<x> specifies the cursor. Valid values are 1 and 2.
<NR3> indicates the value of one of the tics. The units are specified by the
CURSor:VBArs:UNIts command.
CURSOR:VBARS:HPOS2?
might return :CURSOR:VBARS:HPOS2 1.00E-6, indicating the value of one
vertical bar tick.
CURSor:VBArs:UNIts
CURSor:VBArs:POSITION<x>
Sets or returns a horizontal position of the specified vertical bar cursor. The
CURSor:VBArs:UNIts command specifies units. The position can appear in
units of time (s), or frequency (Hz).
Cursor
CURSor:VBArs:POSITION<x> <NR3>
CURSor:VBArs:POSITION<x>?
Examples
Related Commands
Group
Syntax
Arguments
Returns
Examples
Related Commands
Group
Syntax