Tektronix TDS3000 Series - Page 118

Command Descriptions
2-80
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
<x> specifies the cursor. Valid values are 1 and 2.
<NR3> specifies the cursor position in the units specified by the CUR-
Sor:VBArs:UNIts command. The position is relative to the trigger position.
CURSOR:VBARS:POSITION2 9.00E-6
positions vertical bar cursor 2 at 9 s from the trigger.
CURSOR:VBARS:POSITION1?
might return :CURSOR:VBARS:POSITION1 1.00E-6, indicating that vertical bar
cursor 1 is at 1 s.
CURSor:VBArs:UNIts, CURSor:VBArs:HPOS?
CURSor:VBArs:SELect
Selects which vertical bar cursor is active. The active cursor will be displayed as
a solid vertical line and can be moved using the front-panel general purpose knob
when the CURSOR menu is active. The unselected cursor will be displayed as a
dashed vertical line. This command is equivalent to pressing the SELECT
button on the front panel when the CURSOR menu is displayed.
Cursor
CURSor:VBArs:SELect { CURSOR1 | CURSOR2 }
CURSor:VBArs:SELect?
CURSOR1 specifies the first vertical bar cursor.
CURSOR2 specifies the second vertical bar cursor.
CURSOR:VBARS:SELECT CURSOR2
selects the second vertical bar cursor as the active cursor.
CURSOR:VBARS:SELECT?
returns :CURSOR:VBARS:SELECT CURSOR1 when the first vertical bar cursor is
the active cursor.
Arguments
Examples
Related Commands
Group
Syntax
Arguments
Examples