Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2-81
CURSor:VBArs:UNIts
Sets or returns the units for the vertical bar cursors. This command is equivalent
to setting Time Units in the CURSOR menu.
Cursor
CURSor:VBArs:UNIts <QString>
CURSor:VBArs:UNIts?
<QString> is either ”s” for seconds, ”Hz” for Hertz, ”%” for percent, or
”degrees” as the unit of measure.
CURSOR:VBARS:UNITS ”s”
sets the units for the vertical bar cursors to seconds.
CURSOR:VBARS:UNITS?
returns :CURSOR:VBARS:UNITS ”Hz” when the vertical bar cursor units are hertz.
CURSor:VBArs:POSITION<x>
CURSor:VBArs:USE (Set Only)
Sets the vertical bar cursor measurement scale. This command only applicable
when ratio cursors are on.
Cursor
CURSor:VBArs:USE { CURrent | FIVEdivs }
<CURrent> sets the V Bar measurement scale so that 0% is the current position
of the left-most V Bar cursor and 100% is the current position of the right-most
V Bar cursor. Moving the cursors after executing this command does not change
the 0% or 100% scale points.
<FIVEdivs> sets V Bar measurement scale so that 5 screen major divisions is
100%, where 0% is --2.5 divisions and 100% is +2.5 divisions from the center
vertical graticule.
Group
Syntax
Arguments
Examples
Related Commands
Group
Syntax
Arguments
To Next Page
Loading...
