Tektronix TDS3000 Series - Page 120

Command Descriptions
2-82
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
CURSOR:VBARS:USE CURRENT
sets the V Bar measurement scale to use the current cursor positions as 0% and
100% of scale if units are set to %.
CURSor:VBArs:UNIts
CURSor:VBArs:VDELTa? (Query Only)
Returns the vertical difference between the two vertical bar cursor ticks. The
units are specified by the CURSor:HBArs:UNIts query.
Cursor
CURSor:VBArs:VDELTa?
<NR3>indicates the horizontal difference between the two vertical bar cursors.
CURSOR:VBARS:VDELTA?
might return :CURSOR:VBARS:VDELTA 1.064E+0, indicating that the vertical
difference between the vertical bar cursors ticks is 1.064 units.
CURSor:HBArs:UNIts
CURSor:WAVEform? (Query Only)
Returns the active (selected) waveform XY cursor.
Cursor
CURSor:WAVEform?
CURSOR:WAVEform?
might return :CURSOR:WAVEFORM:SELECT CURSOR2.
CURSor:GRATicule?
Examples
Related Commands
Group
Syntax
Returns
Examples
Related Commands
Group
Syntax
Examples
Related Commands