Tektronix TDS3000 Series - Page 135

Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2-97
DATa:TARget
Sets or returns the location for storing waveform data transferred to the
instrument using the CURVe command. This command is equivalent to the
DATa:DESTINATION command and is included for compatibility with older
Tektronix instruments.
Waveform
DATa:TARget REF<x>
DATa:TARget?
<x> specifies reference memory location 1 (REF1) through 4 (REF4).
DATA:TARGET?
might return DATA:TARGET REF2.
CURVe
DATa:WIDth
Sets or returns the number of bytes per data point in the waveform transferred
using the CURVe command.
Waveform
DATa:WIDth <NR1>
DATa:WIDth?
<NR1> = 1 specifies that there is 1 byte (8 bits) per point.
<NR1> = 2 specifies that there are 2 bytes (16 bits) per point. This format is
useful for AVErage waveforms.
DATA:WIDth 1
sets the data width to 1 byte per data point for CURVe data.
CURVe, WFMPre:BIT_Nr, WFMPre:BYT_Nr
Group
Syntax
Arguments
Examples
Related Commands
Group
Syntax
Arguments
Examples
Related Commands