Tektronix TDS3000 Series - Page 148

Command Descriptions
2-110
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
DISPLAY:PICTURE:STATE?
might return DISPLAY:PICTURE:STATE ON, indicating that the video picture
mode is enabled.
DISplay:PICture:BRIghtness, DISplay:PICture:CONTRAst,
DISplay:PICture:AUTOC ontrast
DISplay:STYle:DOTsonly
Selects waveform display style to dots only for XY & YT modes. This command
is equivalent to setting Dots Only in the Waveform Display menu.
Display
DISplay:STYle:DOTsonly { ON | OFF | <NR1> }
DISplay:STYle:DOTsonly?
ON or NR1 ≥ 1 sets the waveform display style to Dots Only.
OFF or NR1 ≤ 0setsDotsOnlytoOff.
DISPLAY:STYLE:DOTSONLY ON
sets the display to Dots Only.
DISPLAY:STYLE:DOTSONLY?
might return :DISPLAY:STYLE:DOTSONLY 1 indicating that the waveform
display is set to Dots Only.
DISplay:VECtorscope:STATE
(Requires TDS3VID or TDS3SDI)
Sets or returns the video vectorscope state setting. This is equivalent to turning
Vectorscope mode on or off from the front panel.
Display
DISplay:VECtorscope:STATE { ON | OFF | <NR1> }
DISplay:VECtorscope:STATE?
Examples
Related Commands
Group
Syntax
Arguments
Examples
Group
Syntax