Tektronix TDS3000 Series - Page 147

Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2- 109
DISplay:PICture:AUTOC ontrast, DISplay:PICture:CONTRAst,
DISplay:PICture:STATE
DISplay:PICture:CONTRAst
(Requires TDS3VID or TDS3SDI)
Sets or returns the video picture mode contrast setting.
Display
DISplay:PICture:CONTRAst <NR1>
DISplay:PICture:CONTRAst?
<NR1> sets the picture contrast value from 0 to 100. DISplay:PICture:AUTOCon-
trast must be OFF in order to set the contrast value.
DISPLAY:PICTURE:CONTRAST?
might return DISPLAY:PICTURE:CONTRAST 45, indicating that the video picture
contrast setting is 45.
DISplay:PICture:AUTOC ontrast, DISplay:PICture:BRIghtness,
DISplay:PICture:STATE
DISplay:PICture:STATE
(Requires TDS3VID or TDS3SDI)
Sets or returns the video picture mode setting.
Display
DISplay:PICture:STATE { OFF | ON | <NR1> }
DISplay:PICture:STATE?
<OFF> or <NR1> = 0 disables video picture mode.
<ON> or <NR1> ¸ 0 enables video picture mode.
Related Commands
Group
Syntax
Arguments
Examples
Related Commands
Group
Syntax
Arguments