Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2- 137
HARDCopy { ABOrt | CLEARSpool | STARt }
HARDCopy?
ABOrt terminates the hard copy output in process.
CLEARSpool is equivalent to ABOrt.
STARt initiates a screen copy that can be stored in a file or redirected to a
printing device.
NOTE. Use the *WAI command between HARDCopy STARt commands to ensure
that the first hard copy is complete before starting another.
HARDCOPY ABORT
stops any hard copy output that is in process.
HARDCopy:COMPRESSion
Sets or returns the hard copy compression feature. Setting this command to On
causes the oscilloscope to compress hard copy output into gnuzip-format files
(*.gz) prior to sending the file out of the specified hard copy port. .gz files are
compatible with GZIP (shareware) or WinZip utilities.
Hard copy
HARDCopy:COMPRESSion [ ON | OFF | <nr1> ]
HARDCopy:COMPRESSion?
ON causes the oscilloscope to compress hard copy output files into gnuzip-format
files (*.gz).
NOTE. Hard copy compression is disabled when the output port is set to
Centronics.
OFF disables hard copy file compression.
nr1 is an integer number where nr1 = 0 turns off compression, and nr1 ≠ 0 turns
on compression.
Syntax
Arguments
Examples
Group
Syntax
Arguments
To Next Page
Loading...
Need help?
General
