Command Descriptions
2- 158
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
LIMIT:STATE?
returns either 0 or 1, indicating whether save waveform to disk or flash drive is
in effect.
SAVEWFM, SAVe:WAVEform:FILEFormat
LIMit:STATE
(Requires TDS3LIM)
Turns limit testing on or off, or returns whether limit testing is in effect.
Limit Test
LIMit:STATE { OFF | ON | <NR1> }
LIMit:STATE?
OFF or <NR1> = 0 turns off limit testing.
ON or <NR1> ¸ 0 turns on limit testing.
LIMIT:STATE ON
specifies that limit testing of waveforms is in effect.
LIMIT:STATE?
returns either 0 or 1, indicating whether limit testing of waveforms is in effect.
CURve, LIMit:BEEP, LIMit:COMPARE:CH<x>, LIMit:HARDCopy, LIM-
it:TEMPLate, WFMPre
LIMit:STOPOnviolation
(Requires TDS3LIM)
Sets or returns the TDS3LIM stop on violation setting. When enabled, this
command stops waveform acquisitions on the first occurance of a limit test
violation. LIMit:STATE must be ON for the oscilloscope to detect violations.
Limit Test
Related Commands
Group
Syntax
Arguments
Examples
Related Commands
Group
To Next Page
Loading...
