Tektronix TDS3000 Series - Page 197

Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2- 159
LIMit:STOPOnviolation { OFF | ON }
LIMit:STOPOnviolation?
OFF = 0 turns off the stop on violation.
ON ¸ 0 turns on the stop on violation.
LIMIT:STOPOnviolation?
might return OFF that indicates the stop on violation is turned off.
MASK:STOPOnviolation
LIMit:TEMPLate (Set Only)
(Requires TDS3LIM)
Uses the values specified by LIMit:TEMPLate:SOUrce, LIMit:TEMPLate:
TOLerance:HORizontal, and LIMit:TEMPLate:TOLerance:VERTical to create a
limit test template and store the template in the reference waveform memory
location specified in LIMit:TEMPLate:DESTination. You can compare the
waveform acquired through the specified channel against this template. The
template can be a waveform saved in any of the reference locations REF1
through REF4.
Limit Test
LIMit:TEMPLate STORe
STORe creates a template with the specified source waveform and tolerances, and
stores it in the destination reference waveform to be used in limit testing
comparisons.
LIMIT:TEMPLATE STORE
creates a template with the specified source waveform and tolerances, and stores
it in the destination reference waveform to be used in limit testing comparisons.
LIMit:TEMPLate:DESTination, LIMit:TEMPLate:SOUrce
Syntax
Arguments
Examples
Related Commands
Group
Syntax
Arguments
Examples
Related Commands