Tektronix TDS3000 Series - Page 225

Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2- 187
MASK:STOPONVIOLATION ON
sets the oscilloscope to stop waveform acquisition on the first occurance of a
waveform violation.
MASK:TESt:BEEP:COMPLetion
(Requires TDS3TMT)
Sets or returns the beep on pass/fail test completion mode. When enabled, this
command causes the oscilloscope to emit a tone when the mask pass/fail test
status changes to either ‘Passed’ or ‘Failed.’
Mask
MASK:TESt:BEEP:COMPLetion { OFF | ON | <NR1> }
MASK:TESt:BEEP:COMPLetion?
OFF turns off pass/fail beep on completion.
ON turns on pass/fail beep on completion.
<NR1> is an integer number where NR1 = 0 turns off pass/fail beep on comple-
tion, and NR1 ≠ 0 turns on pass/fail beep on completion.
MASK:TEST:BEEP:COMPLETION ON
turns on pass/fail beep on completion.
MASK:TESt:BEEP:FAILUre
(Requires TDS3TMT)
Sets or returns the beep on pass/fail test failure mode. When enabled, this
command causes the oscilloscope to emit a tone when the pass/fail status
changes to ‘Failing.’
Mask
MASK:TESt:BEEP:FAILUre { OFF | ON | <NR1> }
MASK:TESt:BEEP:FAILUre?
Examples
Group
Syntax
Arguments
Examples
Group
Syntax