Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2- 243
<NR1> = 0 indicates the oscilloscope is being powered by battery.
<NR1> = 1 indicates the oscilloscope is being powered by AC.
POWER:AC:PRESENT?
might return :POWER:AC:PRESENT 1.
POWer:BATTery:PRESENt?
POWer:BACKLight
Sets or returns the idle time that must elapse before the backlight is turned off.
When the oscilloscope is running on AC power, idle time is ignored.
Miscellaneous
POWer:BACKLight { <NR1> | INFInite }
POWer:BACKLight?
<NR1> = minutes of idle time before the backlight is turned off. 999999999 is
used for infinity, but any value greater than 15 (max timeout) will be rounded to
infinity.
INFinite disables the timer meaning the backlight will not turn off automatically.
POWER:BACKLIGHT 5
sets the backlight to turn off after the oscilloscope has been idle for 5 minutes.
POWer:SHUTdown
POWer:BATTery:GASgauge? (Query Only)
Indicates the remaining charge left in the battery.
Miscellaneous
POWer:BATTery:GASgauge?
Arguments
Examples
Related Commands
Group
Syntax
Arguments
Examples
Related Commands
Group
Syntax
To Next Page
Loading...
Need help?
General
