Tektronix TDS3000 Series - Page 295

Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2- 257
SAVe:SETUp (Set Only)
Saves the current front-panel setup into the specified internal setup location or
file. This is equivalent to selecting the Save Current Setup menu item in the
SAVE/RECALL menu.
Save and Recall
SAVe:SETUp { <NR1> | <file path> }
<NR1> is a value in the range from 1 to 10 and specifies a location. Any settings
that have been stored previously at this location will be overwritten.
<file path> is a quoted string that defines the file name and path. Input the file
path using the form <drive>/<dir>/<filename>. <drive> and one or more
<dir>s are optional. If you do not specify them, the oscilloscope will write the
file to the current directory. <filename> stands for a filename of up to 8
characters followed by a period (“.”) and a 3-char extension. We recommend you
use “.SET” for the extension to identify files that store setup data.
The current directory refers to the name of a directory as returned by the
FILESystem:CWD query.
SAVE:SETUP 5
saves the current front-panel setup in internal setup location 5.
SAVE:SETUP “TEK00000.SET“
saves the current front-panel setup to the file TEK00000.SET in the current
directory.
RECAll:SETUp, *RCL, *SAV
SAVe:WAVEform (Set Only)
Stores a waveform in one of four reference memory locations or a file. This
command is equivalent to selecting the Save Waveform menu item in the
SAVE/RECALL menu.
Save and Recall
SAVe:WAVEform <wfm>,{ REF<x> | <file path> }
Group
Syntax
Arguments
Examples
Related Commands
Group
Syntax