Tektronix TDS3000 Series Program Manual

Command Descriptions
2- 290
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
COMMunication sets the A trigger parameters for communications (mask)
testing. TDS3TMT only.
EDGe sets the oscilloscope to trigger when a signal passes through a single
specified voltage level in a specified direction (edge triggering).
LOGIc sets the oscilloscope to trigger when when the logic condition on two
channels is true. (TDS3000 Series with TDS3TRG, TDS3000B Series,
TDS3000C Series.)
PULse sets the oscilloscope to trigger when a signal meets a specified pulse
width condition. (TDS3000 Series with TDS3TRG, TDS3000B Series,
TDS3000C Series.)
VIDeo sets the oscilloscope to trigger on video signals.
TRIGGER:A:TYPE?
might return :TRIGGER:A:TYPE VIDEO indicating that the A trigger type is a
video trigger.
TRIGger:A:VIDeo? (Query Only)
Returns the A video trigger parameters.
Trigger
TRIGger:A:VIDeo?
TRIGGER:A:VIDEO?
might return: :TRIGGER:A:VIDEO:STANDARD NTSC;SOURCE CH1;FIELD
ALLLINES;HOLDOFF:FIELD 0.0E0;:TRIGGER:A:VIDEO:LINE 1;SCAN RATE1
as the current A video trigger parameters.
TRIGger:A:VIDeo:CUSTom:FORMat
(Requires TDS3VID or TDS3SDI)
Sets or queries the custom video signal format.
Trigger
TRIGger:A:VIDeo:CUSTom:FORMat { INTERLAced | PROGressive }
Arguments
Examples
Group
Syntax
Examples
Group
Syntax

Tektronix TDS3000 Series Specifications

General

Brand	Tektronix
Model	TDS3000 Series
Category	Test Equipment
Language	English