Command Descriptions
2- 302
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
TRIGger:B:STATE
Sets the B trigger level state to on or off.
Trigger
TRIGger:B:STATE { <NR1> | ON | OFF }
<NR1> 0 = off and 1 = on.
TRIGGER:B:STATE 0
sets B trigger state to off.
TRIGGER:B:STATE?
might return :TRIGGER:B:STATE 0
TRIGger:B:TIMe
Sets or queries the B trigger delay time when TRIG:B:BY is set to Time.
Trigger
TRIGger:B:TIMe <NR3>
TRIGger:B:TIMe?
<NR3> is the B trigger delay time, in seconds.
TRIGGER:B:TIME?
might return 1.32E-8. indicating the B trigger is armed 13.2 ns after the A
trigger occurs.
TRIGger:B:TYPe
Sets or queries the type of B trigger. The only valid type is edge.
Trigger
Group
Syntax
Arguments
Examples
Group
Syntax
Arguments
Examples
Group
To Next Page
Loading...
