Command Groups
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2-37
Table 2- 25: Trigger comm ands (cont.)
Header Description
TRIGger:B:BY Sets the B trigger to delay by time or events
TRIGger:B:EDGe? Returns the trigger coupling, source, and the
slope of the B t rigger
TRIGger:B:EDGe:COUPling Sets the B trigger coupling
TRIGger:B:EDGe:SLOpe B trigger slope
TRIGger:B:EDGe:SOUrce B trigger source
TRIGger:B:EVENTS? Returns the current delayed trigger event
parameters
TRIGger:B:EVENTS:COUNt Delay by events count for the B trigger
TRIGger:B:LEVel B trigger level
TRIGger:B:SETLevel Sets the trigger level to 50%
TRIGger:B:STATE Enables/disables the B trigger
TRIGger:B:TIMe Minimum time between A and B trigger
TRIGger:B:TYPe Sets B trigger to edge, logic, pulse, or, video
type
TRIGger:DELay:EDGe:COUPling
TRIGger:DELay:EDGe:SLOpe
TRIGger:DELay:EDGe:SOUrce
TRIGger:DELay:EVENTS:COUNt
TRIGger:DELay:LEVel
TRIGger:DELay:SETLevel
TRIGger:DELay:STATE
TRIGger:DELay:TIMe
TRIGger:DELay:TYPe
Same as the equivalent B trigger commands;
for compatibility with earlier oscilloscopes
TRIGger:EXTERnal:PRObe
(4-channel TDS3000B and TDS3000C
Series oscilloscopes only)
Sets or returns the external input probe factor
TRIGger:EXTERnal:YUNit
(4-channel TDS3000B and TDS3000C
Series oscilloscopes only)
Sets or returns the external input vertical units
TRIGger:FORCe Forces a trigger event
TRIGger:STATE? Returns trigger system status
To Next Page
Loading...
