Tektronix TDS3000 Series Program Manual

Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2-47
ACQUIRE:NUMACQ?
might return 350, indicating that 350 acquisitions took place since an AC-
QUIRE:STATE R UN command was executed.
ACQuire:STATE
ACQuire:NUMAVg
Sets the number of waveform acquisitions that make up an averaged waveform.
This is equivalent to setting the Average count in the Acquisition Mode menu.
Acquisition
ACQuire:NUMAVg <NR1>
ACQuire:NUMAVg?
<NR1> is the number of waveform acquisitions to average, from 2 to 512 (must
be a power of two).
ACQUIRE:NUMAVG 16
specifies that an averaged waveform will show the result of combining 16
separately acquired waveforms.
ACQUIRE:NUMAVG?
might return 64, indicating that there are 64 acquisitions specified for averaging.
ACQuire:MODe
ACQuire:NUMEnv
Sets the number of waveform acquisitions that make up an envelope waveform.
This is equivalent to setting the Envelope count in the Acquisition Mode side
menu.
Acquisition
Examples
Related Commands
Group
Syntax
Arguments
Examples
Related Commands
Group

Tektronix TDS3000 Series Specifications

General

Brand	Tektronix
Model	TDS3000 Series
Category	Test Equipment
Language	English