Command Descriptions
2-48
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
ACQuire:NUMEnv { <NR1> | INFInite }
ACQuire:NUMEnv?
<NR1> ¸ 0 is the number of waveform acquisitions, from 2 to 512 (must be a
power of two). The envelope will restart after the specified number of envelopes
have been acquired or when the ACQuire:STATE RUN command is sent.
INFInite or <NR1> = 0 or 999999999 specifies continuous enveloping.
NOTE. If you set the acquisition system to single sequence, envelope mode, and
set the number of envelopes to infinity, the oscilloscope will envelope a maximum
of 513 acquisitions.
999999999 is returned for INFInite.
ACQUIRE:NUMENV 16
specifies that an enveloped waveform will show the result of combining 16
separately acquired waveforms.
ACQUIRE:NUMENV?
might return 999999999, indicating that acquisitions are acquired infinitely for
enveloped waveforms.
ACQuire:MODe
ACQuire:STATE
Sets or returns the acquisition state. This is the equivalent of pressing the
front-panel RUN/STOP button. If ACQuire:STOPAfter is set to SEQuence,
other signal events may also stop a waveform acquisition.
Acquisition
ACQuire:STATE { OFF | ON | RUN | STOP | <NR1> }
ACQuire:STATE?
Syntax
Arguments
Returns
Examples
Related Commands
Group
Syntax
To Next Page
Loading...
