Command Descriptions
2-58
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
CALibrate:FACtory:CONTInue (Set Only)
Instructs the instrument to execute the current factory calibration step. The
calibration step number is incremented on completion of this step, independent
of the step pass/fail status. Follow this command with CALibrate:
FACtory:STEPstatus? to determine execution status. Use CALibrate:|
FACtory:PREVious (followed by a CALibrate:FACtory:CONTinue) to repeat a
factory calibration step that failed.
If the current step is the last step and the calibration succeeds, new calibration
data (and pass status) is saved to non-volatile memory and the oscilloscope
returns to normal operation in the same state it was in before beginning factory
calibration.
If the current step is the last step and any factory calibration step has failed
(without a successful pass for repeated steps), a fail status will be saved to
non-volatile memory. Factory calibration data will not be saved to non-volatile
memory if the factory status is FAIL.
Calibration and Diagnostic
CALibrate:FACtory:CONTInue
CALibrate:FACtory:NOTIfy:DUE? (Query Only)
Queries if calibration is due.
Calibration and Diagnostic
CALibrate:FACtory:NOTIfy:DUE?
<NR1> = 1 indicates the oscilloscope is due for calibration.
<NR1> = 0 indicates the oscilloscope is not due for calibration.
CALIBRATE:FACTORY:NOTIFY:DUE?
might return :CALIBRATE:FACTORY:NOTIFY:DUE 0 indicating that factory
calibration is not due.
Group
Syntax
Group
Syntax
Returns
Examples
To Next Page
Loading...
Need help?
General
