Teleco TVPLA868CC2 - Change of Automatic Alarm Angles

13
P1 or P2 **
WIND
alarm angle
*
x8
TEMP.
alarm angle
*
x9
SNOW
alarm angle
*
x13
Reset
default
angles
*
x10
Change of the automatic alarm angles
1.1
4.5
Use the following procedures to change the default angles of the pergola slats associated with the alarms.
The system must have been congured and at least one transmitter memorized.
HOLD
complete
closing
complete
closing
Put the slats to
the desired angle,
then:
(5 s)
desired
position
* The buzzer will make a beep each time the button is pressed. ** According to the motor control mode
1 s
continuous
sound
2 s
3 s
continuous
sound
continuous
sound
Press P1 or P2 (**) as many times as required by the type of desired memorization and hold the last time.
The buzzer emits a continuous sound.
complete
closing
4 s
continuous
sound
NOTE: after a new conguration procedure the automatic alarm angles are always reset to default values.