Entry Function
Activation code # Activate relay
The relay operations mode, the activation time and the activation
code, naturally, have to be set correctly to activate the relay via an
activation code.
## x Set volume to x (x=0 to 9)
The volume setting is only valid for the current connection. The
volume can only be permanently set via the configuration steps 06
and 07.
* # Hang up
* * Enter set-up mode (subsequently, enter security code)
Using the touch panel
57www.behnke-online.com
GB
Instructions for Series 5 / 10
▸
Use configuration step code 09 to set the time
interval for relay activation, i.e. the amount of
time (in seconds) the relay will open the door.
▸
Use Configuration step codes 10 and 11
to set the activation codes for the relay. If
you change the default activation code in
configuration step code 10 from 0 to e.g. 55,
the relay will be activated to open the door
by entering 55 followed by the # key on your
telephone with DTMF dialling.
5.4. Control options during voice calls
During voice calls, Behnke Series 5/10 Intercom
stations offer several control options to be
activated using a telephone with DTMF dialling:
To Next Page
Loading...
