Teledyne Oceanscience rapidCAST - Figure 44. BAD Inline Splice; Figure 45. Good Inline Splice

rapidCAST User’s Guide March 2018
EAR-Controlled Technology Subject to Restrictions Contained on the Cover Page.
Page 77
• The inline splice should be intact and not walking out. There is a high risk of losing the probe if
the splice starts to walk out. The inline splice is only held by friction and is strongest when loaded.
Figure 44. BAD Inline Splice
Note how it is starting to walk out. Re-tighten or replace.
Figure 45. Good Inline Splice