User Manual
56
The following table describes the parameters of this page.
Field Description
Enable Tick in the box to enable a firewall rule.
Protocol
Choose a protocol corresponding to the rule. You
may choose TCP, UDP or ICMP.
Action
The action when the rule is matched. Permit means
allowing the message to pass, Drop means
discarding messages without a reply, and Reject
means discarding messages with a reply.
Reject Type
The type of message sent in a Reject action.
Icmp Type
Type of ICMP messages
origIPAddress
Original IP address
origMask
Original address mask
origStart/End Port
Original start/ end port, which is the original port
range
destIPAddress
Destination address
To Next Page
Loading...