Defines the behaviour of the Device.
Operations
R/W LOCAL
R/W REMOTE
Becomes effective
Instantly
Notes
Use of bit 8 or bit D requires bit 1 to be unset.
NODELEFT indicates that an end device has left
from anywhere in the network, but only routers
within one hop from the COO are indicated.
Storage
Non-Volatile
Parameters
XXXX
Where XXXX represents a 16-bit hexadecimal
number.
Range
0000 to FFFF
Bit F: Add prefix to local S-register reads
Bit E: Show RSSI and LQI for all received
unicasts, broadcasts and AT+PANSCAN
reports
Bit D: Set: Display incoming ZDO messages by
RX prompt instead of normal text prompt
Bit C: Set: Message payload of RX prompt is
displayed as hexadecimal instead of
ASCII text
Bit B: Set: Show NODELEFT prompt on COO
when a device leaves the PAN
Bit A: Set: Add remote endpoint and Network
address to ACK and NACK prompts for
profile IDs other than the Telegesis one
Bit 9: Set: Disable SWRITE prompt
Bit 8: Set: Show unhandled messages received
by Endpoints 1 and above
Bit 7: Set: Hide “AddrResp” prompt
Bit 6: Set: Hide Network Manager Warning
Bit 5: Set: Hide “DataMODE” prompt
Bit 4: Set: Hide “CLOSED” prompt
Bit 3: Set: Hide “OPEN” prompt
Bit 2: Set: Hide all Sink Advertisements
Unset: Show all Sink Advertisements,
except advertisements by the current sink
Bit 1: Set: Disable showing unhandled
messages received by all Endpoints
Bit 0: Set: Disable COO, FFD, SED and MED
prompts
Factory Default
0006
To Next Page
Loading...