Installation and User Manual
Televic Conference Systems
12. Main Menu
Config menu selection allows entering the
different settings as described below
All selected settings are activated immediately
except for “restore factory settings” which needs
additional confirmation.
12.1. Loudspeaker volume
Adjust the loudspeaker volume of the system.
The loudspeakers setting are the same for a delegate
as for a chairman.
Loudspeaker volume is adjustable between 0dB and -
46dB + “OFF”
12.2. Conference modes
In order to guide a conference several conference
modes are available.
Chairman microphones are not affected by any
conference mode and can be activated at any time
with a maximum of 8 chairman units.
12.2.1. Direct Access
This enables the participant to turn on his
microphone at any time by pressing the MIC icon on
his conference unit.
Several participants can be active simultaneously
until the microphone limit setting (see chapter 12.5)
is reached.
The chairman can cancel all the active microphones
by short pressing the PRIOR icon. This can cause a
chime audio signal (on the condition this setting is
activated: see chapter 12.9).
Holding the PRIOR button will temporarily mute all
active microphones. Releasing the button will return
the state of the microphone before the PRIOR button
was pressed.
Activation mode
In the direct access mode there is an additional
setting to define the way a delegate is granted the
floor.
Toggle
Represented by animation sequence
The microphone icon needs to be pressed to activate
the unit and once more to deactivate the unit.
Push to talk
Represented by animation sequence
The microphone is only active as long as the MIC icon
is pressed.
12.2.2. Override (1-8)
Makes it possible to activate 1 to 8 delegates
simultaneously depending on microphone limit
setting (see chapter 12.5)
To Next Page
Loading...
