Televic D-CERNO - 13. Web-browser; 13.1. How to connect

D-Cerno Wired System
Installation and User Manual
Televic Conference Systems
V0.4 - December 6, 2012
44
13. Web-browser
13.1. How to connect
13.1.1. Step 1 – PC or MAC TCP/IP
setup
In order to access the built-in webserver for the first
time, the TCP IP settings from the PC or MAC must be
modified. A fixed IP address has to be set. Therefore
follow the instructions below.
Assigning a Static IP Address in WINDOWS 7
- Go to ‘Control Panel’ (refer to Figure 13.1)
- Double-click on Network and Sharing center
Figure 13.1: Control Panel
- Click on Change adapter settings
(Refer to Figure 13.2)
Figure 13.2: Network and sharing
- Right-click on Local Area Connection ( refer
to Figure 13.3)
- Click on Properties
Figure 13.3: Local Area Connections
- Click on Internet Protocol 4 (TCP/IPv4) (refer
to Figure 13.4).
Figure 13.4: Local Area Connections Properties
- Click properties
- Input your IP Address and subnet mask
(refer to Figure 13.5).
The IP Addresses on the network must be
within the same range. The default IP
address from the central unit is
192.168.0.20 so the computer should have
an IP Address that is within the same
subnet, like 192.168.0.11 and 192.168.0.21.
The subnet mask must be the same for all
equipment on the network: 255.255.255.0)
- Click OK
Note:
The D-cerno CU-R has a default fixed IP
address and subnet mask:
 IP: 192.168.0.20
 Subnet mask: 255.255.255.0