Televic D-CERNO - 17. D-Cerno CUR startup options

D-Cerno Wired System
Installation and User Manual
Televic Conference Systems
V0.4 - December 6, 2012
60
17. D-Cerno CUR startup
options
The D-Cerno CUR has two startup triggers:
 On / Off button
 Connection with the power supply
This choice can be made by setting a hardware
switch in a certain position. The default trigger is the
On / Off button. To change this to automatic startup
when the power supply is connected, please follow
the following steps:
 Make sure nothing is plugged in in the D-
Cerno CUR.
 Remove the screws at the back of the units
as shown below.
 Carefully remove the front of the unit. The
location of the switch is marked in red
below.
 Below a close-up of the switch. The startup
option is the lower switch. By default (On /
Off switch mode) the switch is positioned to
the left. To change the mode to start from
the moment to power is supplied to the unit
the switch needs to be positioned to the
right, as shown in the picture below.
 Carefully reassemble the unit.
Note:
Before switching on the central unit
please make sure all units are correctly
connected to the Central Unit.