Installation and User Manual
Televic Conference Systems
it is possible to activate a maximum of 8 chairman
units.
12.6. Eco mode
The central unit has an ECO function that is going
into low power mode when no sound has been
detected for more than 30 minutes.
The eco mode can be set on or off.
12.7. Settings menu
12.7.1. Factory settings
When the factory settings reset is selected and
confirmed, the CU will reboot with its default
settings. (See chapter 14)
If a factory settings reset is required, please wait
until the D-Cerno CU has completely started up, so
the ON/OFF LED is switched off. Then a factory reset
can be performed.
12.7.2. System info
Displays general system info as shown in example
below
Software version, serial number, IP address, subnet
mask and MAC address of the CUR.
12.8. Headphone volume
Adjust the headphone volume of the CU
The headphone volume of the central unit can be
adjusted via the central unit menu.
12.9. Chime
Whenever the chairman uses the prior button, a
chime tone will be audible
The chime mode can be set on or off.
12.10. External processing
12.10.1. Independent aux
settings
Auxiliary input and output settings are independent
form each other and allow external signal to be
added to the floor and to extract the total floor signal
Audio path for Independent Aux settings.
V 0801
SN 13A00009
IP 192.168.0.20
SM 255.255.255.0
MAC 00:0E:3D:10:04:D6
To Next Page
Loading...
